Stampede4ever

Does anyone know of a wire brush, sanding disk of some sort, and where to buy it at?

Thanks.

gto69judge

iTrader: (32)

A high pressure stream of water from a my 3500 psi pressure washer works pretty well. On the outside of a building I have heated the paint with an acetylene torch and scraped it off. I have also used a needle scaler to quickly remove thick paint from block using low pressure. See the links below.

http://www.northerntool.com/webapp/w...3724_200113724

http://www.northerntool.com/webapp/w...70_12817_12817

04LS1GTO

Needle scaler works but is time consuming and loud. Rent the biggest pressure washer you can find and try that.

barkingspud

iTrader: (3)

Soda blast it....Concrete block is incredibly porous and will soak through leaving water in the center for weeks. Get a sand blaster and put baking soda in it....