Small Mill Base??
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Sep 2007
Location: Portland OR
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Hey all, I recently purchased a "drill press" accessory for my dremel and I was wondering if anyone could point me in the direction of a small mill base so that I could use it sorta like a mini mill. Nothing fancy just little aluminum parts like coil brackets for my motorcycle and what not.
This is what I am talking about ---> http://www.mytoolstore.com/dremel/drillprs.html
This is what I am talking about ---> http://www.mytoolstore.com/dremel/drillprs.html
#2
TECH Senior Member
iTrader: (1)
Join Date: Nov 2001
Location: Waco, TX
Posts: 6,449
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Probably a little more than you want to spend (I paid less than this for my mill-drill
) but Grizzly sells a cross table. $325 plus $77 shipping...
http://grizzly.com/products/H7659
That's probably the smallest / cheapest cross slide table I've seen, unfortunately.
Then again, some cross-slide vises may do the trick:
http://grizzly.com/products/Cross-Sl...Vises-4-/H0967
http://www.grizzly.com/products/g1064
![Icon Lol](https://ls1tech.com/forums/images/smilies2/icon_lol.gif)
http://grizzly.com/products/H7659
That's probably the smallest / cheapest cross slide table I've seen, unfortunately.
Then again, some cross-slide vises may do the trick:
http://grizzly.com/products/Cross-Sl...Vises-4-/H0967
http://www.grizzly.com/products/g1064
Last edited by Camaroholic; 09-10-2008 at 08:29 PM.