E-Bay headers sticky
Originally Posted by ChocoTaco369
i guarantee someone will pay $250-$300 for your month old "rusted pacesetters." you could take that $250-$300 and buy these headers. that way, you'll only be out ~$100-$150. that's not too bad.
Tech Resident
Joined: Jan 2006
Posts: 5,117
Likes: 3
From: Philly
Originally Posted by bww3588
will they hook up to TSP TD's? if so, i might go this route.
i can't imagine TSP duals not fitting on ANY header. even if it's off by 2 inches, that's a very small problem for a good exhaust shop. put it in the pipe bender, inch it over a few degrees or have them weld on an inch or two of pipe as an extention and BAM, you're in business.
Originally Posted by bww3588
sorry, that was an inside thing...........
on a serious note, i wish i had waited now.....i could have stainless for less $$$ than i paid for my rusted pacesetters. that pisses me off. i could never take mine off and sell them. hell id be out so much i could afford to buy QTP's or somthing like that......son of a bitch...(kicks self).
on a serious note, i wish i had waited now.....i could have stainless for less $$$ than i paid for my rusted pacesetters. that pisses me off. i could never take mine off and sell them. hell id be out so much i could afford to buy QTP's or somthing like that......son of a bitch...(kicks self).
Originally Posted by Nine Ball
bww3588, I suggest you read this thread and think about how your latest replies in this thread appear.
https://ls1tech.com/forums/showthread.php?t=705999
Pay special attention to the thread title.
https://ls1tech.com/forums/showthread.php?t=705999
Pay special attention to the thread title.
Originally Posted by Tainted
yea but honestly how often are the obx ones even mentioned? 2 people got them and had bad luck with'em so the words out already on them.
I do think the y-pipe is a little low though.
