Need a 9" center section or a 10 bolt
Need a 9" center section or a 10 bolt I'm trying to locate a vibration I picked up when I put my moser 9" in. If anyone has an extra 9" center section that takes 31 spline axles, I'd like to swap it with my center section just to see if the vibration goes away, wouldn't even leave the driveway. Also if anyone has an extra 10 bolt laying around I'd like to swap my rear out just to test that also. I wouldnt even be leaving the driveway, so I'd only need to borrow them for the weekend. Will come pick them up of course. Somebody help me out! 
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo I have adjustable control arms, so I pulled the rear end closer to the transmission to make up for it being a little too short. I have about 1" of the driveshaft showing out of the back of the transmission, so I have that covered too 
. Like I said I've already gone through everything haha.
. Like I said I've already gone through everything haha. I have adjustable control arms, so I pulled the rear end closer to the transmission to make up for it being a little too short. I have about 1" of the driveshaft showing out of the back of the transmission, so I have that covered too . Like I said I've already gone through everything haha.
. Like I said I've already gone through everything haha. By moving the rear axle forward 1" it made the driveshaft the perfect length. Unless moving the rear axle forward for some reason would cause a vibration that I am unaware of?
give it a shot, mine was about a year since i was in iraq and they asked no questions, i didnt have an invoice, order number anything. bc i swore at the time they told me a moser 9" takes a stock length shaft. mine ended up a little more that 1" longer bc i have 28" tires and had to move the rearend back to clear the front of the wheelwell.