alignment shop???
Thread Starter
11 Second Club
iTrader: (10)
Joined: Feb 2006
Posts: 2,215
Likes: 2
From: Sterling Heights, MI
alignment shop??? i just got my MWC 9" in my car and i cant for the life of me get the damn rear end straight in the car. im either 1/8" one way or 1/4" the other way and im just too damn frustrated to fix it. I dont mind paying someone that will do it right and knows that their doing and can do it with more than a tape measure and dumb luck lol.
(at this point i know im trying to split hairs but) It would be great too if the could fix my exhaust while its there. I had to angle my duals so far downward to fit the t/q arm that literally the under the axle part hits the reflectors in the road lol. i just need it cut up and my second set of bullets put into the X system, looking to dump it before the axle with turndowns again
anyone got any ideas?
(at this point i know im trying to split hairs but) It would be great too if the could fix my exhaust while its there. I had to angle my duals so far downward to fit the t/q arm that literally the under the axle part hits the reflectors in the road lol. i just need it cut up and my second set of bullets put into the X system, looking to dump it before the axle with turndowns again
anyone got any ideas?
Thread Starter
11 Second Club
iTrader: (10)
Joined: Feb 2006
Posts: 2,215
Likes: 2
From: Sterling Heights, MI
i have all that, i have adj LCAs, panhard and tq arm and i am just very very bad at measuring/tightening/torquing. I know it may sound reatrded, but i just am. I jsut some extra $$ laying around from a few snakes i sold and would rather just have the piece of mind that it was done "profesionally" and not have to bother with it all.
