mrws6speed

I just put 4.10 Gears in my '02 WS6 Vert. I need to re-calibrate my speedo now.

I would like to eventually get around to tuning my car....but I'd rather not spend hundreds of dollars right now just to recalibrate the speedo.

If anyone is so inclined to help out....it would be greatly appreciated.

hotrod_bljak

iTrader: (3)

Well, where in NM are you at. If you are over on the eastern side, you could always go to Lubbock. Texas Speed is there. I did a dyno there a few months ago. There were a few of us, so it was cheaper than it would have been if I went by my self. i hope this helps.

mrws6speed

Thanks for the input. I'm in Albuquerque...little bit further to drive to lubbok (especially with gas prices now! )

hotrod_bljak

iTrader: (3)

I understand. Well, I hope you the best of luck finding a place up in your neck of this state. later!

lowprofile

iTrader: (3)

I'm in ABQ and I'll need a tune myself. I called a local dyno shop, but they don't tune. They refered me to another shop that does the tune, but rents the dyno from the other shop. $165/hr (includes rental of dyno), said it would be 2 hours for my head/cam swap. I have one good referance for them. Don't know of their LSx experience though... PM me for the mane of the shops...

-A few of us at Kirtland AFB are trying to get a cruise together around here if your interested...

-G

lowprofile

iTrader: (3)

-just realized youre not looking for a dyno tune... but they can probably help you with your speedo...

mrws6speed

Well....dyno tune is the next step. I'll be making other mods where it'll be useful. I know a great shop that's putting in a killer dyno setup. The problem is they don't tune LSX cars (but I can use the dyno if I can get someone to tune).

I'll PM you...I'm interested in getting together for a cruise.