Bob's Big Boy in Burbank this Friday night 3/14/08...
#61
#63
boy was that a bitch, we still have to fine tune it tho, i fixed the pop out while you drive, but now we have to shorten the wire from the actuator because the plate has resistance now, and it wont pop out.
i figure since the pull wire is lose, if we make it shorter, the actuator will pull at full force.
since that loop is pressed together to close the loop, how can we unclip it to make it shorter
i figure since the pull wire is lose, if we make it shorter, the actuator will pull at full force.
since that loop is pressed together to close the loop, how can we unclip it to make it shorter
#64
#66
boy was that a bitch, we still have to fine tune it tho, i fixed the pop out while you drive, but now we have to shorten the wire from the actuator because the plate has resistance now, and it wont pop out.
i figure since the pull wire is lose, if we make it shorter, the actuator will pull at full force.
since that loop is pressed together to close the loop, how can we unclip it to make it shorter
i figure since the pull wire is lose, if we make it shorter, the actuator will pull at full force.
since that loop is pressed together to close the loop, how can we unclip it to make it shorter
#69
i unbent the bottle opener a lil and put duct tape around and through the loop to provide grip, it was working fine,i drove around and then i made a left on my street and i heard the plate go down.