19" CCW 505a's
05-07-2011, 06:31 PM
#42
TECH Apprentice
iTrader: (2)
Join Date: Jul 2010
Location: Oklahoma City, OK/North Long Beach/Paramount, CA
Posts: 394
Likes: 0
Received 0 Likes
on
0 Posts
so rear is 19x12 w/ 345-30's and on stock 10 bolt? 
btw looks great i like how it sits flush/tuck in the rear
get a shot of that rear w/ those tires
btw looks great i like how it sits flush/tuck in the rear
get a shot of that rear w/ those tires
05-07-2011, 08:52 PM
#43
11 Second Club
Thread Starter
iTrader: (7)
Join Date: Sep 2005
Location: Eagle Pass, TX
Posts: 1,930
Likes: 0
Received 0 Likes
on
0 Posts
They are 11's out back...but they're on 345's... 
Yes, stock 10 bolt measurements.
Yes, stock 10 bolt measurements.
Last edited by PERFECT Z28; 06-06-2011 at 01:12 PM. Reason: size correction
05-09-2011, 10:17 AM
#52
11 Second Club
Thread Starter
iTrader: (7)
Join Date: Sep 2005
Location: Eagle Pass, TX
Posts: 1,930
Likes: 0
Received 0 Likes
on
0 Posts
Updated pics: (from Fri night)
pic1:
installed the DS LCA
pic2:
PS before
pic3:
after trimming and PS LCA installed
pic4:
pic5:
pic6:
pic7:
pic8:
where the quater panel was rubbing on bumps...
I took out some stock rear springs from one of my other camaros to see if I can get a better ride height.
(I'm hopin to install these sometime this week.)
I might just buy some adjustable coil perches, try a coil spring spacer OR make my own spring spacer to help with the " PS lean"...about 3/4" DIF
Once I'm finished with the "construction part" of this, I'll clean up the underside and spray it with a black rubberized undercoating to give it a stock look.
...and of course, I'll start cleaning up the rims...lol
pic1:
installed the DS LCA
pic2:
PS before
pic3:
after trimming and PS LCA installed
pic4:
pic5:
pic6:
pic7:
pic8:
where the quater panel was rubbing on bumps...
I took out some stock rear springs from one of my other camaros to see if I can get a better ride height.
(I'm hopin to install these sometime this week.)
I might just buy some adjustable coil perches, try a coil spring spacer OR make my own spring spacer to help with the " PS lean"...about 3/4" DIF
Once I'm finished with the "construction part" of this, I'll clean up the underside and spray it with a black rubberized undercoating to give it a stock look.
...and of course, I'll start cleaning up the rims...lol
Last edited by PERFECT Z28; 05-09-2011 at 11:14 AM.
05-12-2011, 06:17 PM
#58
11 Second Club
Thread Starter
iTrader: (7)
Join Date: Sep 2005
Location: Eagle Pass, TX
Posts: 1,930
Likes: 0
Received 0 Likes
on
0 Posts
I know its gonna take a lot of work, maybe even years...lol
They should stay clean since I rarely drive the car...
I'm actually going to clean the undercarriage and paint it.
They should stay clean since I rarely drive the car...
I'm actually going to clean the undercarriage and paint it.