Need help choosing the right lugnuts.
Thread Starter
9 Second Club NA
iTrader: (180)
Joined: Mar 2003
Posts: 5,943
Likes: 1
From: Houston, TX
Need help choosing the right lugnuts. I have a 12 bolt coming soon with standard studs, so I will need to order a set of standard lugnuts. I need the shank style open end and Summit lists 3 of them in which they have different shank lengths.
MCG-60127 .490"
MCG-61005 .746"
MCG-63004 1.365"
All of them have the centered round washer, is that what I need? Not sure what length of shank I need, could someone help me to choose the right one? Thanks.
MCG-60127 .490"
MCG-61005 .746"
MCG-63004 1.365"
All of them have the centered round washer, is that what I need? Not sure what length of shank I need, could someone help me to choose the right one? Thanks.
I'll assume this is Jeremy...hopefully I was able to help you out successfully and everything worked out for the best.
If i'm incorrect on my assumption of whom this is, please let us know what rim your using.
Steve
If i'm incorrect on my assumption of whom this is, please let us know what rim your using.
Steve
Thread Starter
9 Second Club NA
iTrader: (180)
Joined: Mar 2003
Posts: 5,943
Likes: 1
From: Houston, TX
Yes, this is Jeramy. Everything is much clearer now. I appreciate your help.
Now to the bad news, I called McGard and visited their site as well and they do not have open end shank style lugnuts with a shank length between .746 and 1.365. The .746 is too short and the 1.365 is too long. If I were to use a thicker washer, then that would bring the lugnut further out so that I wouldnt bottom out on the rotor, but it would also mean that its pulling it back on the stud as well which will affect how much of the hex portion will be on the stud. I need a 1/2" x 20 open end shank style lug nut with a shank length of around an 1". I dont see any on Summit's site, what do I do?
Now to the bad news, I called McGard and visited their site as well and they do not have open end shank style lugnuts with a shank length between .746 and 1.365. The .746 is too short and the 1.365 is too long. If I were to use a thicker washer, then that would bring the lugnut further out so that I wouldnt bottom out on the rotor, but it would also mean that its pulling it back on the stud as well which will affect how much of the hex portion will be on the stud. I need a 1/2" x 20 open end shank style lug nut with a shank length of around an 1". I dont see any on Summit's site, what do I do?
