Y2k's
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Jun 2006
Posts: 606
Likes: 0
From: Staten Island, New York
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Jun 2006
Posts: 606
Likes: 0
From: Staten Island, New York
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Jun 2006
Posts: 606
Likes: 0
From: Staten Island, New York
2000taws6 - thanks for the link but I think most people will prob only be looking for the two rear wheels and they only offer sets BUT......i just found this site that sells individual 18x10.5's for $215 a piece with no tax and no shipping 
go to customwheelsmarket. Also, what tires are you running with the 10.5's and did u need to modify anything to make em fit? I just want to make sure before getting too excited lol cuz I dont want to have to modify
BUT......i just found this site that sells individual 18x10.5's for $215 a piece with no tax and no shipping go to customwheelsmarket. Also, what tires are you running with the 10.5's and did u need to modify anything to make em fit? I just want to make sure before getting too excited lol cuz I dont want to have to modify Last edited by jpticar; Dec 7, 2007 at 08:44 AM.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo I paid less than 800 for the set. It has been a couple years though. My rear tires are 295/35/18 BFG KDW's. I used a 1/4" spacer and beat on the inner fenders a little just for good measure. They probably would have worked just fine without any mods but I want to step up to 315/30/18's and lower it about 1" in the future.
Anyway, you just had to add a 1/4 spacer too the rear's correct? And do they not fit without the spacer or what?? I have been really wanting to get the y2k's but never found a nice picture with them on and being black; until today that is. Also wanted to do the same as your setup with the 18's , 9.5 front, 10.5 rear. So basically what im asking is do you think ill need that spacer and why would i need it if i did, and im not to much of a fan of it if i do have to roll my fender but might. Thanks!