DEI 561T Remote Start
Thread Starter
TECH Enthusiast
iTrader: (16)
Joined: Jun 2005
Posts: 732
Likes: 1
From: San Luis Obispo, CA
DEI 561T Remote Start What is the best way to bypass VATs so it is only bypassed when the remote start engages? I have the module from eBay but I don't want to completely disable this function.
Also, does anyone have a good wiring diagram for the ignition switch harness?
Thanks.
Also, does anyone have a good wiring diagram for the ignition switch harness?
Thanks.
DPDT relay. Center connections going to the PCM. NC connections going to the connector in the steering column. NO connections going to a resistor (or combination of resistors) that matches the resistor in your key.
Connect the relay coil to the ignition disable output on the starter. [Strongly] consider adding a diode across the coil to protect the starter outputs (1N4001 - 1N4007 family would do).
Connect the relay coil to the ignition disable output on the starter. [Strongly] consider adding a diode across the coil to protect the starter outputs (1N4001 - 1N4007 family would do).
