Alternator bracket template
#1
Alternator bracket template
Here is my design for the alternator only bracket I am using. This mounts the alternator high on the drivers side. Mine is 1/8" aluminum, but if I had it to do over, I would use 1/4". I can't seem to post them here, so email me for a copy. The drawing is in ACAD 2000 .dwg and .dxf formats.
Here is a picture of the bracket on my car. The drawings are a cleaned up version of the prototype.
Here is a picture of the bracket on my car. The drawings are a cleaned up version of the prototype.
#4
On The Tree
Join Date: Feb 2003
Location: Sydney, Australia
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
Nice job....but does the alternator have any lateral movement with that bracket? It doesn't look rigid enough to stop any forward/rearward movement. Why didn't you use the C5 Corvette OEM bracket?
#5
The bracket works great. I made the bracket non-adjustable due to the belt tensioner. I have had no flex problems in the last 2 years it has been on the car either. The bottom bolt of the alternator is attached to both the front and rear brackets and creates a surprisingly sturdy piece. Like I said above, I would use 1/4" if I made another one and I would use the same bracket for the front and rear.
I chose to make my own instead of use the C5 version for a few reasons. One was cost. It was much cheaper to make one than buy a new C5 bracket. And the other is I didn't want to change my crank pulley and belt tensioner to the C5 version. And you have to remember that when I did my conversion, there were not a lot of other people doing it and parts were not as readily available as they are today.
I chose to make my own instead of use the C5 version for a few reasons. One was cost. It was much cheaper to make one than buy a new C5 bracket. And the other is I didn't want to change my crank pulley and belt tensioner to the C5 version. And you have to remember that when I did my conversion, there were not a lot of other people doing it and parts were not as readily available as they are today.
#7
TECH Fanatic
iTrader: (1)
Join Date: Dec 2003
Location: Farmington Hills, MI
Posts: 1,098
Likes: 0
Received 0 Likes
on
0 Posts
Here are some CATIA drawings of the plate and the complete assembly. I can send 3D data if anyone can read it and wants it. The dimensions of the holes are what's really important. The edges of the part can be whatever looks best, as long as it doesn't hit anything.
Trending Topics
#11
richard.lazard@us.army.mil
Thank You
Richard
#15
Hello
Would like to have a copy if possible!?!
Thanks info@radhofgarage.ch
Greatings fom switzerland
Would like to have a copy if possible!?!
Thanks info@radhofgarage.ch
Greatings fom switzerland
#16
Cad drawing
Here is my design for the alternator only bracket I am using. This mounts the alternator high on the drivers side. Mine is 1/8" aluminum, but if I had it to do over, I would use 1/4". I can't seem to post them here, so email me for a copy. The drawing is in ACAD 2000 .dwg and .dxf formats.
Here is a picture of the bracket on my car. The drawings are a cleaned up version of the prototype.
Here is a picture of the bracket on my car. The drawings are a cleaned up version of the prototype.
thanks
ktooker@energexcp.com
#17
TECH Senior Member
70 LS1 hasn't been here for over 8 years.
The following users liked this post:
NCDEERE (01-24-2020)