Advice on which 4L80E to buy!
#1
12 Second Club
Thread Starter
iTrader: (9)
Join Date: Jun 2006
Location: Grand Forks, North Dakota
Posts: 1,051
Likes: 0
Received 0 Likes
on
0 Posts
Advice on which 4L80E to buy!
I am going to do a m6 to 4l80e swap in the next few months. I have some questions and want opinions.
1. I want a transbrake.
2. I want it to be electronic.
3. I want it to stand up to over 1000hp.
4. I want a good stall..maybe 3200?
What input do you guys have? Where to buy, what other options?
I have done some reading and plan on getting a wiring harness and reprogramming stock computer with HP Tuner software to recognize new trans.
Looking for input.
Thanks in advance!
1. I want a transbrake.
2. I want it to be electronic.
3. I want it to stand up to over 1000hp.
4. I want a good stall..maybe 3200?
What input do you guys have? Where to buy, what other options?
I have done some reading and plan on getting a wiring harness and reprogramming stock computer with HP Tuner software to recognize new trans.
Looking for input.
Thanks in advance!
#2
I would be happy to discuss this build with you... as a matter of fact, I have a very well built 4L80E on the shelf right now. It would not be hard at all to install a t-brake setup and take it to the next level!
We help guys with these conversions often.
g
We help guys with these conversions often.
g
#3
TECH Resident
iTrader: (64)
Join Date: Jul 2005
Location: sneaking in your back door as you leave!/cartersville ga
Posts: 908
Likes: 0
Received 0 Likes
on
0 Posts
I am going to do a m6 to 4l80e swap in the next few months. I have some questions and want opinions.
1. I want a transbrake.
2. I want it to be electronic.
3. I want it to stand up to over 1000hp.
4. I want a good stall..maybe 3200?
What input do you guys have? Where to buy, what other options?
I have done some reading and plan on getting a wiring harness and reprogramming stock computer with HP Tuner software to recognize new trans.
Looking for input.
Thanks in advance!
1. I want a transbrake.
2. I want it to be electronic.
3. I want it to stand up to over 1000hp.
4. I want a good stall..maybe 3200?
What input do you guys have? Where to buy, what other options?
I have done some reading and plan on getting a wiring harness and reprogramming stock computer with HP Tuner software to recognize new trans.
Looking for input.
Thanks in advance!
2. if your making that kind of power, i would think you need a bigger stall than 3200.
3. there is only one company making a trans-brake for a 4l80e, but i believe they are selling it to the public now.