cals400ex

iTrader: (27)

i am looking to replace anything that i should. for example, should the flex plate be replaced? i am also considering the rear main seal. is there any other parts or bolts/nuts that should be replaced during the stall/tranny install? i am pretty excited to get my new yank in. tonight i ran 12.6. i just can't pull better than a 2.0 60-ft with the stock stall.

jimmyblue

iTrader: (11)

Turbine shaft seal O-ring, and front seal on the trans at
least.

cals400ex

iTrader: (27)

i will be buying a rebuilt trans. i would assume it would come with a new front seal. i don't even know what the turbine shaft seal is?

TORK?

iTrader: (27)

New converter bolts

00Formula00

iTrader: (6)

Have some extra E-Clips laying around just in case they decide to fly away when you are taking the trans cooler lines off....