lq4 swap
#5
I'm in the process of an LQ4 swap from my LS6 right now. I'll post some pics up of my newly fabbed motor mount plates when finished. Crossing my fingers on the fitment, they should work just fine though.
Trending Topics
#9
#11
#13
My old motor was a bored/stroked iron 5.3 the new motor is a iron 6.0
I'll have to look but I don't think I have any pictures of my mounts I built unless there's some in my build thread on CF
I'll have to look but I don't think I have any pictures of my mounts I built unless there's some in my build thread on CF
#14
#18
I actually didn't make these, a guy from the tool room at my work did them for me. He spent the better part of a week getting all the measurements and alignment right. I'm still worried its going to be very tight clearancing in some areas, and I may only be able to attach with 3 bolts per plate. Keeping my fingers crossed.
If I were you I would explore the GTO or truck mounts to see if they can be fabbed/morphed to accept the V mounting location. I wish I would have looked into that route beforehand just to give me 2 options. Let me know what you find out.
If I were you I would explore the GTO or truck mounts to see if they can be fabbed/morphed to accept the V mounting location. I wish I would have looked into that route beforehand just to give me 2 options. Let me know what you find out.