New Motor in the 67
Trending Topics
#9
Teching In
Join Date: May 2009
Location: Statesville,NC
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Seen many a Fulton motor rip it up here in NC at Mooresville, Farmington,Shuffletown & Hudson.
#11
Staging Lane
Thread Starter
iTrader: (4)
Join Date: May 2007
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
here is a picture from the side, ill also post a picture of the car before the changes, from last season. Its goin in our outlaw 10.5 camaro. The old set up was a 632ci with 2 stages of nitrous. With the new setup were looking for low 4.40s to high 4.30s in the 1/8th.
#15
That's insane...what'd that run you about $85K? I didn't even know motors went that big (I was seeing some 815/830 in IHRA Pro Stock).
Curious as to why you have 5 stages of nitrous for an 1/8th mile run? You running a Liberty 5 speed and hitting a stage each gear? Can you even get to 5th in the 1/8th mile? 3 Speed, leaving on one and hitting two each 2nd/3rd?
Curious as to why you have 5 stages of nitrous for an 1/8th mile run? You running a Liberty 5 speed and hitting a stage each gear? Can you even get to 5th in the 1/8th mile? 3 Speed, leaving on one and hitting two each 2nd/3rd?
#16
Staging Lane
Thread Starter
iTrader: (4)
Join Date: May 2007
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
its pretty much done by timers, its a three speed lenco with a torque converter. All depending on your tune up, the first one comes on off the line, followed by another at .8, 1.2, 2.0, and 2.5