Stand alone wiring question
#1
Teching In
Thread Starter
Stand alone wiring question
I'm about ready to start building my 2002 5.3 truck harness into a stand alone harness. I have done a lot of reading in the stickys but i still have a couple questions ref the check engine light. Can i use a regular bulb type light or does it have to be a led? C2-46 is the PCM pin number but where do i connect the other side of the check engine light. Thanks
https://ls1tech.com/forums/conversio...eg-canada.html
https://ls1tech.com/forums/conversio...eg-canada.html
Last edited by JML55; 01-29-2009 at 10:02 PM.
#5
Teching In
Thread Starter
Got the wiring harness almost done. One thing i'm not sure about is that i dont know if i should remove wire C1-70 blue connector, oil level switch. If i remove it will the pcm be looking for that signal.