converting dbw to cable
#1
converting dbw to cable
Helloe everyone I am converting from 2001 corvette to camoro PCMs I need to know the wiring for the trottle body I have the correct pins from an old Harness I just need to plug them into my PPCM
Basicly I purchased the new 2001 camoro throttle body and removed my old dbw throttle body put the plugs are different I have the corect plugs but need to plug them into the pcm
ANy help would be appreciated
Basicly I purchased the new 2001 camoro throttle body and removed my old dbw throttle body put the plugs are different I have the corect plugs but need to plug them into the pcm
ANy help would be appreciated
#5
TECH Addict
iTrader: (22)
Its not difficult. First determine if your PCM even supports the IAC. Red/Blue PCMs always do, blue/green sometimes
If it's compatible, depin the two serial wires that went from the TAC module to the PCM and add the 7 wires for the TPS/IAC. All the TAC module and pedal wiring can come out too
Flash in a DBC tune, swap the TB itself, set a cable bracket and you're done
The above diagram is only valid for 99+ red/blue PCMs. Green/blues changed pinouts slightly. This site has more specific info on the green/blue's
http://www.lt1swap.com/cable_conversion.htm
If it's compatible, depin the two serial wires that went from the TAC module to the PCM and add the 7 wires for the TPS/IAC. All the TAC module and pedal wiring can come out too
Flash in a DBC tune, swap the TB itself, set a cable bracket and you're done
The above diagram is only valid for 99+ red/blue PCMs. Green/blues changed pinouts slightly. This site has more specific info on the green/blue's
http://www.lt1swap.com/cable_conversion.htm