converting dbw to cable

Reply Subscribe

Thread Tools

Search this Thread

Jul 17, 2010 | 02:10 PM

jarias

Thread Starter

Teching In

Joined: May 2010

Posts: 5

Likes: 0

converting dbw to cable

Helloe everyone I am converting from 2001 corvette to camoro PCMs I need to know the wiring for the trottle body I have the correct pins from an old Harness I just need to plug them into my PPCM

Basicly I purchased the new 2001 camoro throttle body and removed my old dbw throttle body put the plugs are different I have the corect plugs but need to plug them into the pcm

ANy help would be appreciated

Jul 17, 2010 | 02:19 PM

Pocket

TECH Addict

iTrader: (22)

Joined: Apr 2009

Posts: 2,657

Likes: 149

From: NC

This should help

PM sent about the old DBW stuff

Jul 17, 2010 | 05:41 PM

jarias

Thread Starter

Teching In

Joined: May 2010

Posts: 5

Likes: 0

Thank you exactly what i was looking for

Jul 18, 2010 | 01:05 AM

Quickfrc

On The Tree

iTrader: (10)

Joined: Jul 2010

Posts: 116

Likes: 0

is there a thread on how to do this swap?

Jul 18, 2010 | 08:55 AM

Pocket

TECH Addict

iTrader: (22)

Joined: Apr 2009

Posts: 2,657

Likes: 149

From: NC

Its not difficult. First determine if your PCM even supports the IAC. Red/Blue PCMs always do, blue/green sometimes

If it's compatible, depin the two serial wires that went from the TAC module to the PCM and add the 7 wires for the TPS/IAC. All the TAC module and pedal wiring can come out too

Flash in a DBC tune, swap the TB itself, set a cable bracket and you're done

The above diagram is only valid for 99+ red/blue PCMs. Green/blues changed pinouts slightly. This site has more specific info on the green/blue's
http://www.lt1swap.com/cable_conversion.htm