Yoke U joint size. Camaro t56 + Corvette 69
05-14-2013, 04:49 PM
#1
Staging Lane
Thread Starter
Join Date: Oct 2012
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Yoke U joint size. Camaro t56 + Corvette 69 Hi,
Measured my yoke this weekend and thought I would order my new driveshaft today but there were many more options then I thought when it came to U-joints.
The yoke is from a camaro 2002 t56 and I need to know what size the U-joints are?
Anyone know what the diff side of the driveshaft on a 69 corvette auto sb takes for U-joint?
If anyone knows this it would be greatly appritiated, been searching all around but havn't found any solid answers.
Thanks!
Measured my yoke this weekend and thought I would order my new driveshaft today but there were many more options then I thought when it came to U-joints.
The yoke is from a camaro 2002 t56 and I need to know what size the U-joints are?
Anyone know what the diff side of the driveshaft on a 69 corvette auto sb takes for U-joint?
If anyone knows this it would be greatly appritiated, been searching all around but havn't found any solid answers.
Thanks!
05-14-2013, 04:59 PM
#2
TECH Senior Member
iTrader: (7)
Hi,
Measured my yoke this weekend and thought I would order my new driveshaft today but there were many more options then I thought when it came to U-joints.
The yoke is from a camaro 2002 t56 and I need to know what size the U-joints are?
Anyone know what the diff side of the driveshaft on a 69 corvette auto sb takes for U-joint?
If anyone knows this it would be greatly appritiated, been searching all around but havn't found any solid answers.
Thanks!
Measured my yoke this weekend and thought I would order my new driveshaft today but there were many more options then I thought when it came to U-joints.
The yoke is from a camaro 2002 t56 and I need to know what size the U-joints are?
Anyone know what the diff side of the driveshaft on a 69 corvette auto sb takes for U-joint?
If anyone knows this it would be greatly appritiated, been searching all around but havn't found any solid answers.
Thanks!
Andrew
05-14-2013, 05:06 PM
#3
On The Tree
iTrader: (3)
Join Date: Aug 2011
Location: WA
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
You need to measure the diameter and width of each side of the u-joint caps and match them up. You can look at the link below to see what what measurements correspond with what joint.
http://www.dennysdriveshaft.com/c130...al_joints.html
If you dont measure, you risk ordering the wrong parts. On my 1970 Nova I ordered a 1350 yoke for my t56 and didnt measure and found out I had a GM 3R to 1310 conversion joint on one end and a 1310 to 1330 conversion joint on the other. There is no telling what has made it onto your car over the years.
http://www.dennysdriveshaft.com/c130...al_joints.html
If you dont measure, you risk ordering the wrong parts. On my 1970 Nova I ordered a 1350 yoke for my t56 and didnt measure and found out I had a GM 3R to 1310 conversion joint on one end and a 1310 to 1330 conversion joint on the other. There is no telling what has made it onto your car over the years.
