AJE Crossmember Problem
#1
AJE Crossmember Problem
So I already emailed AJE earlier today and haven't gotten a reply, but I'm curious if anyone else has had this problem or if I'm missing something here.
I have the T56 crossmember for my fox and I went to mock it up today to measure for a driveshaft and it doesn't fit. The flanges that are attached to the frame rail where the crossmember bolts up has about 3" of space between them but the bushing for the crossmember are about 4-1/2" long.
I'm probably going to pop out the bushing and pin and cut it to fit. I'm just curious if anyone else has run into this problem.
I have the T56 crossmember for my fox and I went to mock it up today to measure for a driveshaft and it doesn't fit. The flanges that are attached to the frame rail where the crossmember bolts up has about 3" of space between them but the bushing for the crossmember are about 4-1/2" long.
I'm probably going to pop out the bushing and pin and cut it to fit. I'm just curious if anyone else has run into this problem.