Need help on PCM and Harness
#21
Launching!
iTrader: (18)
Join Date: Mar 2004
Location: Paris, Tx.
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ALL UC2
sorry, i have to disagree with you.i have used a factory harness and 2 aftermarket harnesses and i would use a factory one anyday of the week over a made one. i think its easier.
Also, for the original poster, www.Thirdgen.org will have some good specific info for your Camaro swap. Good luck.
#24
yup it is good info, I have a question to add, Im not that good about all this wirring problems, but I have an engine and an Auto tranny from a Camaro 98' and im doing my swap on a 240sx, I already have everything from a 98 model camaro... what problems will I face? and Where can I get wirring diagrams and Pinouts for my ECU from?!
Thanks...
Thanks...
#26
I am attempting to use a 02 silverado harness in a LS1 swap into a 95 Z-28. I noticed a color difference on the #4 injector. I know it is the same injector but the wire color looked different. This is the first time I have attempted this so I feel a little paranoid.....I also noticed and extra sensor clip at the end of the even side fuel injector harness. I assume i could just wire that into the modded harness?
#27
Registered User
Join Date: Aug 2014
Location: Maui Hawaii
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I have a 2001 Camaro ss and installing a new lsx376.
im used to working on older motors with no computer so I hope you guys can help.
can I use the 2001 harness and computer to run the lsx???
im used to working on older motors with no computer so I hope you guys can help.
can I use the 2001 harness and computer to run the lsx???