SySt666

iTrader: (4)

What is everyone using as far as the fitting on the power steering pump pressure port goes? I am to go from 6 AN to whatever the pump requires.

bczee

iTrader: (12)

You can get a 16x1.5mm o-ring adapter to AN fitting.. I am using this on my Chevelle. You will have to use something like Russesll Powerflex Teflon line Braided Hoses to handle the high pump pressure. Normal Power steering hose can be used on the low side.

67rsss

iTrader: (4)

THese are the parts I have on order for LS1 into 67 Camaro. I have a diagram of this drawn up on my fquick, it is also discussed in our swap thread. If you are going to build your own hoses, it is critical that you use a system rated for power steering use (like the Russel Powerflex line). All fittings must be steel! No aluminum in this stretch.

AER-FBM2608 $13.95 (1) Straight, Steel, -6AN to 16mm 1.5 male with o-ring.
$13.95 P/S Pump adapter

AER-FBM2965 $6.95 (1) Adapter, Steel, 11/16 inv Flair to -6AN
$6.95 P/S Gear adapter, pressure side

AER-FBM2964 $6.95 (1) Adapter, Steel, 5/8 Flare to -6AN
$6.95 P/S Gear adapter, return side

RUS-620421 $12.95 (3) Fitting, Hose end, 90 Degree, Power steering -6AN
$38.85 Power steering

RUS-632600 $18.88 (2) Hose, Powerflex, -6AN, 3ft
$37.76 Power steering hose

Even though you don't need the fancy line on the return side, we wanted the same look for both lines. You can save a little on the hose and one fitting if you use a barb and regular 3/8 fuel hose.

Steve68

iTrader: (23)

Where did you get the fittings?????

67rsss

iTrader: (4)

All part number listed are the Summit numbers, a couple fittings we sourced from other places, but when we started putting together the fluid hookup infor, I decided to list everything from one source, so I picked Summit as just about everyone has an account with them.

Steve68

iTrader: (23)

Thanks

Jeff Smith

iTrader: (44)

Thank you so much..I have been trouble to find the right fitting for my 2001 Camaro Rack to custom PS tank.