garys 68

iTrader: (1)

I need to make a harness between the TAC module and pedal assembly for 2002 escalade LQ9.
The schematic I have shows all the lettered pinouts (A,B,C, etc) between the pedal and Tac module correspont, except E and J, they're switched.
Is this corect, or a mistake.
Also, does anyone have the TAC module pinout order or diagram? I want to confirm "A" is upper left.

Ram Air IV

Here is the electric scheme for the LQ9 TAC-module.

Magnus

V8Rumble

iTrader: (9)

Excellent, thank you!

garys 68

iTrader: (1)

That makes 2 versions where pin E and J are switched, so I'm guessing it's correct.
Thanks

garys 68

iTrader: (1)

Just when I thought all were in agreement, I just looked at the vette DBW schematic.
It has ALL TAC pinouts and pedal assembly corresponding to each other, including "E" and "J".
Anyone know for sure which wiring version is correct?

Jones'n

The vette setup matches up letter for letter, that is correct.
On the truck TAC, E and J do switch.

Both vehicles are wired differently.

garys 68

iTrader: (1)

Thanks!