NX_CaGEdApE00

iTrader: (7)

I am in the process of building a CAI for my camaro to complete the project..

Question is what material would be best to use???? What size????

and i am considering running over top of the radiator(radiator has been dropped down a bit) and splitting into 2 pipes running each into the 2 front holes in bumper with a cone filter sticking out of each hole???

or would it beneficail running just one pipe into one side or not??

Should i mount my IAT sensor close to the filter??

thanks guys.. any suggestions appreciated!!


P.S. This car sees very little street time.... Mostly Drag Car

NX_CaGEdApE00

iTrader: (7)

any help??

BADFNZ

iTrader: (19)

I used rubber and silicon.

https://ls1tech.com/forums/drag-racing-tech/542310-my-custom-cold-air-intake.html

Nate_Taufer

iTrader: (1)

Check out SUX2BU's homeade cai. Works extremely well for cheap.

Nate

NX_CaGEdApE00

iTrader: (7)

i have no air lid!!!! Upper and lower radiator supports are tubular.....

any other ideas...

tektrans

iTrader: (23)

Tom the Roofer's got a real cool set up using black abs drain pipe from Home Depot.