Notching Radiator support
#1
Launching!
Thread Starter
iTrader: (15)
Join Date: Jan 2008
Location: St. Augustine FL
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
Notching Radiator support
ok i have seen alot of build pics where people cut the support back until the radiator is almost vertical my question is how are you doing this. are you just notching the support or fabbing up a whole new support.Advice whould be great.I attached a pic of a car i have seen it done on for refference
#2
TECH Resident
iTrader: (19)
ok i have seen alot of build pics where people cut the support back until the radiator is almost vertical my question is how are you doing this. are you just notching the support or fabbing up a whole new support.Advice whould be great.I attached a pic of a car i have seen it done on for refference
#3
TECH Senior Member
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
on my old setup we left the upper support there, cut out the lower support and replaced with tube. for the cap, we used a hole saw and piece of pipe to form a channel to fit around the rad cap...