Saleen S7 TT

Coming from 6000 ft NV to 1000 ft MN, what size pulley should I run or should I keep it the same and adjust the fuel/air ratio? Previous owner believes it is currently a 3.4" pulley.

Here are the specs:

• Stock short block
• Patriot P&P 243 heads
• Thunder TR224-112
• Mac Mid headers with off road Y pipe and Gibson cat back
• BBK 80mm TB
• P1SC Procharger with Dual inter coolers runs at 7 PSI
• LS6 intake
• 60lb Motrons
• Racetronix fuel pump
• Performabuilt Level 2 with Performabuilt billet 2800 rpm converter Trans has less than 500 miles on it
• Good trans cooling system
• Strange driveshaft
• Moser 9" w/ 3.70 gears Rear has 4k miles on it
• Chrome C6 staggered wheels
• Toyo Proxes 4 245/17 front
• NEW Nitto 555 Drag Radials on rear 275/17
• New Bilsteins all the way around
• Strut tower brace
• BMR torque arm
• BMR PHB
• BMR LCAs
• Mac weld in subframe connectors
• NGK wideband mounted in-car
• Autometer fuel pressure and boost gauges in pod in pillar

Thanks for any input!

Bob@BruteSpeed

iTrader: (16)

I replied to your pm yesterday. You'll have to let me know what you end up deciding to do. Bob