DS98Formula Build Thread
#45
TECH Resident
Thread Starter
iTrader: (3)
Join Date: Mar 2008
Location: Joliet Illinois
Posts: 965
Likes: 0
Received 0 Likes
on
0 Posts
Deleted my side molding and also pained my fender vents to match my bird decals. Now I just need to paint my calipers. and get yellow overlays for my Formula emblems
#51
TECH Resident
Thread Starter
iTrader: (3)
Join Date: Mar 2008
Location: Joliet Illinois
Posts: 965
Likes: 0
Received 0 Likes
on
0 Posts
After a year of having them I finally put my duals on. Dumped for now.
This is what my restrictive y pipe looked like. It was a terrible bend job at a local shop. I was cheap and I am sure it cost me power.
You cant tell in this picture but the other side of this is flat on one side where they went under the driver side
This is how much they crushed it at the bends
Kind of hard to tell here too but the welds they shrunk at the pipes pretty bad so it necked down a lot at each weld.
I am thinking now that I have a true 3 inch exhaust and went to duals that I picked up a bit of power due to how bad the y pipe was. So since my last dyno I have added a ported tb and true duals. I can not wait to get back to the dyno to see what I picked up
This is what my restrictive y pipe looked like. It was a terrible bend job at a local shop. I was cheap and I am sure it cost me power.
You cant tell in this picture but the other side of this is flat on one side where they went under the driver side
This is how much they crushed it at the bends
Kind of hard to tell here too but the welds they shrunk at the pipes pretty bad so it necked down a lot at each weld.
I am thinking now that I have a true 3 inch exhaust and went to duals that I picked up a bit of power due to how bad the y pipe was. So since my last dyno I have added a ported tb and true duals. I can not wait to get back to the dyno to see what I picked up
Last edited by ds98formula; 07-27-2014 at 12:14 PM.