Bluchevypick

iTrader: (70)

I just recently took in a job replacing a knocking motor in a 98 camaro with my built iron ls1. I finally got the install all done and now the car wont start. I never heard it run before i pulled it out cause it had a hole in block. i replaced the crank sensor cause i know that it has no spark but has plenty of fuel. i do have the 3 grounds on the back of drivers head. those are all the grounds i recall. Any help is appreciated.

brian_rs/ss

what does it do when you turn the key?

Bluchevypick

iTrader: (70)

It does turn over just dont start.

"Grabby" 2000Z28

iTrader: (1)

You are sure its getting fuel through the injectors into cylinders ?
So , you have pulled a plug wire and no spark from wire to plug or ground .

armyboyatc

iTrader: (29)

I had the same problem. try plugging a scan tool into the OBD2 connector and starting it up while that is plugged up. Let me know if it works.

Bluchevypick

iTrader: (70)

Finally got the car started. The green wire going to the crank sensor had a bad spot in it.

"Grabby" 2000Z28

iTrader: (1)

All right !