2000Z28M6

iTrader: (13)

I purchased a used LS6 intake it didnt come with the stock seals where it meets the heads, can I reuse the old ones from my LS1 intake or do I have to get some new 1s? Anyone have a part # for these or the price?

badpewter-z

iTrader: (4)

12533587 is what ya need . they are consideried reusable but i never would ,

2000Z28M6

iTrader: (13)

ighht just wondering, I'll check into the pricing. thanks for the part #

2000Z28M6

iTrader: (13)

checked the pricing....lists for 67.58 does anyone know if I could re use the ones on the LS1 intake

Danny2tek

iTrader: (1)

what $67.58 for seals?

dand35th

reuse them , they will be fine..

Z28GSXRTim

I had to buy 8 when I painted my intake manifold. I looked at them and they were extremely flat- I don't think I would have gotten a good seal out of them. I didn't pay anymore than $2 per gasket. It's piece of mind to replace the gaskets, I ALWAYS do it whenever I take something apart, even if they are 'reusable'.

badpewter-z

iTrader: (4)

no there not cheap but definetly good piece of mind . for me atleast

2000Z28M6

iTrader: (13)

$2 a piece sounds ok where did you get them?

furiouSS99

iTrader: (-1)

has anyone ever tried turning them around? They look brandnew underneath...the only trick is you have to cut the little tag on one corner to make it fit.

Z28GSXRTim

Dealership- so I am sure there other places where you can get them cheaper.

Zanthius

$38 at gmpartsdirect.com

Stew w/92&00

I reused mine,no problems....

slt200mph

iTrader: (42)

My Z06 intake has been on and off a number of times on two cars..no problem...they are very reuseable....keep in mind that u don't tork em down very tight..they seal up great...just my 2 cents

Z28GSXRTim

I agree, my intake had been taken off several times when troubleshooting burnt valves and bad rings. Plus I was having some funky LTFT's problems. I figured it was just good to check off on a list of what I did.