Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Stock Rev limit?

Thread Tools
 
Search this Thread
 
Old 12-01-2003, 01:36 PM
  #1  
12 Second Club
Thread Starter
iTrader: (6)
 
bad2000ss's Avatar
 
Join Date: Sep 2003
Location: Burbank, CA
Posts: 793
Likes: 0
Received 0 Likes on 0 Posts
Default Stock Rev limit?

Hey dudes, i have a 2000 SS M6 and i would like to know what the stock rev limit is set to. I have hit the limiter before, but i'm too busy looking at the road to pay attention to the tach. I have read it is set to 6250rpm but i am still not sure. Just finished a few drivetrain mods and I have a set of 26" tall et streets i am going to use and want to figure out at what mph i will hit the rev limiter in 4th. Thank you very much in advance.
Old 12-01-2003, 04:08 PM
  #2  
TECH Veteran
iTrader: (6)
 
2001CamaroGuy's Avatar
 
Join Date: Feb 2002
Location: Phoenix, AZ USA
Posts: 4,766
Received 0 Likes on 0 Posts

Default

6200 sounds about right.......
Old 12-01-2003, 04:10 PM
  #3  
STF veteran / 10 second club
iTrader: (14)
 
x phantom x's Avatar
 
Join Date: May 2003
Location: New York
Posts: 3,376
Likes: 0
Received 1 Like on 1 Post
Default

I'm pretty sure it is right around 6200 ... give or take 50 rpms (6150-6250)
Old 12-01-2003, 04:42 PM
  #4  
Cal
TECH Veteran
iTrader: (1)
 
Cal's Avatar
 
Join Date: Feb 2003
Location: Northern Utah
Posts: 4,692
Likes: 0
Received 3 Likes on 3 Posts

Default

It was set to exactly 6200 rpm in my 2001 SS.
Old 12-01-2003, 04:44 PM
  #5  
12 Second Club
Thread Starter
iTrader: (6)
 
bad2000ss's Avatar
 
Join Date: Sep 2003
Location: Burbank, CA
Posts: 793
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks for the feedback, I hope to be mid to low 12's by the end of the year and i'd hate to have to go to 28" slicks, these 26" only have a couple passes on them.




All times are GMT -5. The time now is 09:57 PM.