ls1 bore/hone
07-14-2005, 01:05 PM
#1
Teching In
Thread Starter
Join Date: Jun 2005
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
ls1 bore/hone was given a ls1 short block, stock crank,rods,ross pistons,arp hardware. it sat for about 6/8 months, he did spray wd-40 into the cylinders. there is a slight amount of rust on the walls, can the bores safley be touched with a hone to clean up ? also can it be bored at all ?
scot
scot
07-14-2005, 02:08 PM
#3
Launching!
Join Date: Jun 2005
Location: longview, tx
Posts: 202
Likes: 0
Received 0 Likes
on
0 Posts
These blocks are usually just honed, even when going to bigger pistons. Of course the bigger pistons are only a few thou bigger. Not enough meat there to bore like a normal block. I'll bet you'd be just fine with a light honing.
