Stock Push Rods OK with milling?
#1
Launching!
Thread Starter
Join Date: Oct 2004
Location: PA
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
Stock Push Rods OK with milling?
I recently purchased AFR heads, I had them milled to 64 CC's. I will be using the .040 Cometic gasket. Cam is 230 228 LSA is 112 (X1)
Are my 7.4 pushrods still ok?
What will my CR be? I only run 93 so I think I'm ok, clarification would be appreciated.
Thanks
Dave
Are my 7.4 pushrods still ok?
What will my CR be? I only run 93 so I think I'm ok, clarification would be appreciated.
Thanks
Dave