"Notch" in cylinder wall... Thoughts?
01-29-2007, 02:36 PM
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Aug 2004
Location: Kannapolis, NC
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
"Notch" in cylinder wall... Thoughts? As you can see below, this in in a cylinder wall, towards the top of the cylinder wall. It's like a "divit" in the wall, very small, yet your fingernail catches it as you pass over it. Is this a concern? I'm thinking that ANY abnormality in a cylinder wall is bad, but if this "divit" is above the piston rings, then should I worry?
Picture quality sucks, but you get the idea, I'll post more pics tonight.
Picture quality sucks, but you get the idea, I'll post more pics tonight.
