Need 4.020 Pistons! Any Sponsors?
#1
Teching In
Thread Starter
Join Date: May 2009
Location: Under the Bonnet SYDNEY Australia
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Need 4.020 Pistons! Any Sponsors?
I'm building a L76 6.0L that came out of a burnt out Cop car.
Water had been left sitting in the Bore's from when the Fire Fighters had put the car out....
The Bore's are to far gone to get away with a light Hone
So now I have to grab some Pistons & Rings, also if the price is right I'll grab some Rods.
I've already done a search of the Classified Threads & sent a few PM's..
So if there is any1 out there selling or know any1 possably selling:
4.020 or 4.030 FORGED FLAT's (Preferably with Valve Relief)
If any Sponsors could PM me with prices, that would be much appreciated!
BTW: I live in Australia so I'd need it Shipped Internationally obviously.
Cheers!
Water had been left sitting in the Bore's from when the Fire Fighters had put the car out....
The Bore's are to far gone to get away with a light Hone
So now I have to grab some Pistons & Rings, also if the price is right I'll grab some Rods.
I've already done a search of the Classified Threads & sent a few PM's..
So if there is any1 out there selling or know any1 possably selling:
4.020 or 4.030 FORGED FLAT's (Preferably with Valve Relief)
If any Sponsors could PM me with prices, that would be much appreciated!
BTW: I live in Australia so I'd need it Shipped Internationally obviously.
Cheers!
Last edited by Torque666; 08-16-2009 at 07:09 AM.
#3
Teching In
Thread Starter
Join Date: May 2009
Location: Under the Bonnet SYDNEY Australia
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Ok.. Ive since been informed that the Bore's on these things are as thin as ***!
& was advised that I shouldnt really go any further then 10thou oversize for it to be reliable..
Can any1 confirm these harsh accusations??
& was advised that I shouldnt really go any further then 10thou oversize for it to be reliable..
Can any1 confirm these harsh accusations??
#6
Teching In
Thread Starter
Join Date: May 2009
Location: Under the Bonnet SYDNEY Australia
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
I had an optical at the stores you mentioned (online) LSXHAWK.
It looks like i'm up for Rods aswell... Nothing seems to come with a FKN .945 Wrist Pin!
+ then i'll need Bearings if thats the case.
I got this Engine Cheep, But all said & done.. The eventual cost of this re-build, I might as well of just imported a complete fkn crate Motor!