rotary guy who saw the light :)
#1
rotary guy who saw the light :)
was a a big time rotard head, till now i have finally seen the light, after riding in my buddies 6.0 swapped grand national with big single i was perty much hooked
this is what i was sporting before.... gt42 REW powerd fc........ quick to say the least, but i want scary fast and reliable
Now look at the happy new home ready for a 4.8/4l60 with a s475 BW single
car will weigh no more than 2600lbs, should be fun to say the least
this is what i was sporting before.... gt42 REW powerd fc........ quick to say the least, but i want scary fast and reliable
Now look at the happy new home ready for a 4.8/4l60 with a s475 BW single
car will weigh no more than 2600lbs, should be fun to say the least
Last edited by rotary1307cc; 04-01-2008 at 09:03 PM.
#6
#7
Hello,
Welcome to LS1TECH!
I have been in the same boat as you for way too long!
Welcome to the Dark Side!
I think you will be very happy with your new power plant!
On a side note.
That's a nice Rotary setup!
I see your using Haltech? E6k?
Are you looking to sell the rotary engine, I have a nice 90 Turbo II that has been without an engine since I bought my LS1 and it's in need of a strong replacment engine. May I ask who built it?
Sorry for the
Again, welcome to Ls1tech!
BT
Welcome to LS1TECH!
I have been in the same boat as you for way too long!
Welcome to the Dark Side!
I think you will be very happy with your new power plant!
On a side note.
That's a nice Rotary setup!
I see your using Haltech? E6k?
Are you looking to sell the rotary engine, I have a nice 90 Turbo II that has been without an engine since I bought my LS1 and it's in need of a strong replacment engine. May I ask who built it?
Sorry for the
Again, welcome to Ls1tech!
BT
Trending Topics
#12
TECH Enthusiast
Join Date: Aug 2006
Location: Memphis, TN
Posts: 542
Likes: 0
Received 0 Likes
on
0 Posts
#14
yep I wanna do something at least a little different too.
not too worried about needing alot of cubes........ even at 425 wheel with the auto in a 2600lb car that could put it in the vicinity of 10's.....600 would be mid 9's for sure
I was pulling 1.5 60fts with this car on just 7" FWD slicks with the rotary on the stock 7" rear diff...........so it gets out of the hole without much effort
not too worried about needing alot of cubes........ even at 425 wheel with the auto in a 2600lb car that could put it in the vicinity of 10's.....600 would be mid 9's for sure
I was pulling 1.5 60fts with this car on just 7" FWD slicks with the rotary on the stock 7" rear diff...........so it gets out of the hole without much effort