270 rwhp 380 rwtq
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Aug 2006
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
270 rwhp 380 rwtq
96 z28 with a catback and pcm4less tune..not bad? Dyno'd it today and that's the numbers ill post the dyno sheet when I get on a real comp right now im on my phone.. Lol
*thanks Speedtek Performance for getting me in for a dyno on last minute notice*
*thanks Speedtek Performance for getting me in for a dyno on last minute notice*
#6
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Aug 2006
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Open cutout=270.22rwhp 344.08rwtq
Closed cutout=262.40rwhp 379.14rwtq.
On a dynojet. I have the dyno sheet to back it up. I thought it was a little out there too. But I've posted before on how either one of the previous owners put something in it I don't know about or its simply one of those "holy **** that things stock" cars.
Closed cutout=262.40rwhp 379.14rwtq.
On a dynojet. I have the dyno sheet to back it up. I thought it was a little out there too. But I've posted before on how either one of the previous owners put something in it I don't know about or its simply one of those "holy **** that things stock" cars.
Trending Topics
#15
TECH Resident
iTrader: (1)
Join Date: Sep 2005
Location: Elko MN
Posts: 833
Likes: 0
Received 0 Likes
on
0 Posts
yeah the torque is totally outrageous! as a comparison my car, also an m6, with very few mods put down almost 271 hp but only 314 ft/lbs tq
but the difference, my numbers are realistic
380 must have been some sort of spike, did you snap the throttle open right away or did you roll into the gas when starting the dyno?
with hp as similar as it is to my dyno you should check out what the dyno looks like in the link in my sig and see how it compares
but the difference, my numbers are realistic
380 must have been some sort of spike, did you snap the throttle open right away or did you roll into the gas when starting the dyno?
with hp as similar as it is to my dyno you should check out what the dyno looks like in the link in my sig and see how it compares
#20
11 Second Club
iTrader: (35)
Something isn't right, obviously by the fact LT1's put down that torque with full boltons + heads/cam. When I was cam only and was consitently putting down 335rwtq I put down 405rwtq on one pull when the operator kicked it down to second by accident and then took it thru third. So many variables that can lead to much inflated numbers.