diy twins....
05-02-2009, 01:51 PM
#1
TECH Apprentice
Thread Starter
iTrader: (13)
Join Date: Jan 2008
Location: godley
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
diy twins.... well i started doing mine today and everything was going good till i tried to take a piece of hose off the walbro that i cut too short....then i broke the damn barb off the pump pulling on it. so my cheap easy set up just went up 100 bucks. anyone doing this be careful with the barbs they break alot easier than you would think. other than that its easy as hell to do the conversion. murphys law sux!
05-04-2009, 08:31 PM
#2
11Second Club
iTrader: (3)
Join Date: Dec 2004
Location: Dallas (Richardson), TX, USA
Posts: 1,294
Likes: 0
Received 0 Likes
on
0 Posts
Just FYI, I had to redo my setup a couple times for various reasons, and I just bought a foot of SAE 30R10 rated fuel hose and would cut the hose off and put new stuff on each time. This way I didn't have to tug on any fittings... I just sliced them off with a razor blade.
