Fitting for gauge and pressure sensor?
#1
12 Second Club
Thread Starter
iTrader: (12)
Join Date: Oct 2007
Location: Dayton, Ohio
Posts: 1,340
Likes: 0
Received 0 Likes
on
0 Posts
Fitting for gauge and pressure sensor?
I'm in the middle of my install and ran into some problems. I'm looking at doing something like this with the pressure gauge and pressure sensor for bottle heater coming off of one fitting straight off of the bottle:
So I'm looking at this:
http://www.nitrousoutlet.com/catalog...roduct_id=2714
and this:
http://www.nitrousoutlet.com/catalog...product_id=369
Whats the difference between these? I assume the more expensive one is better but why?
thanks in advance for your help.
So I'm looking at this:
http://www.nitrousoutlet.com/catalog...roduct_id=2714
and this:
http://www.nitrousoutlet.com/catalog...product_id=369
Whats the difference between these? I assume the more expensive one is better but why?
thanks in advance for your help.
#7
FormerVendor
iTrader: (4)
Join Date: Jul 2005
Location: Glenolden, PA
Posts: 1,954
Likes: 0
Received 0 Likes
on
0 Posts
We offer them in blue, red, black or clear. http://www.harrisspeedworks.com/shop...&cat=38&page=1
Nick
Nick
Trending Topics
#8
FormerVendor
iTrader: (25)
You are seeing the difference of the NX mark up. Dont get me wrong these fittings can be made from different materials and some of the china made ones sometimes have a sealing issue. For the most part many of them are close to the same.
We stock the swivel style as well but we do not have the swevin style in a dual port at this time. However you can loosen the bottle nut and position the fitting in any position you like.
Dave
We stock the swivel style as well but we do not have the swevin style in a dual port at this time. However you can loosen the bottle nut and position the fitting in any position you like.
Dave