4.11s in stock 10 bolt
#1
10 Second Club
Thread Starter
iTrader: (11)
Join Date: Apr 2009
Location: Lake of the Ozarks, MO
Posts: 2,283
Likes: 0
Received 1 Like
on
1 Post
4.11s in stock 10 bolt
Im wanting to changed the rear end gears in my Firehawk. It has the stock 10 bolt, I want to go with 4.11s. Will I need to change anything other than the ring and pinion? Wont need a new locker or anything right?
#2
you might wanna get the complete rebuild kit which includes new bearings and everything...oh and with 4.10's might wanna get some dr's if you already dont lol
#3
12 Second Club
iTrader: (7)
Join Date: Mar 2008
Location: Mid-Missouri
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
There are tons of write ups about this. Unless you can do all this yourself, it is best to save the money and put it towards a new rear end. I was gonna do the same thing till I found out that it was gonna cost around $500 for the install, that wasn't including the gears or install kit. Just my .02 on the issue.
#5
10 Second Club
Thread Starter
iTrader: (11)
Join Date: Apr 2009
Location: Lake of the Ozarks, MO
Posts: 2,283
Likes: 0
Received 1 Like
on
1 Post
Why should I rethink that? Its not a track car..Its a toy, take it to small car shows and play around on the streets..The car doesnt make 1200 RWHP and never will..if the stock rear goes oh well Ill get a new one one the time comes
Im going to do it myself with help from some a buddy..Iv got a Moser 9in if this one goes out but I dont want to put it in...power robber!!
Im going to do it myself with help from some a buddy..Iv got a Moser 9in if this one goes out but I dont want to put it in...power robber!!