SpeedThrift

I am stuffing an LQ4 under the hood of my 95 GMC 1500.

Does anybody have dimensions to make a motor mount adapter plate?

poconojoe

iTrader: (43)

http://matt.undiagnosed.org/ls1/imag...ount_plate.jpg

http://matt.undiagnosed.org/ls1/imag...t_plate_V2.jpg

Search is your friend, learn to use it

Marky522

iTrader: (8)

I have a set i will sell for $30 shipped. They were wrong for my project.

Mark

SpeedThrift

Thanks for the dimensions!

52 Rat

iTrader: (4)

I'm glad I found this thread. Are the attached drawings for the left and right sides?

poconojoe

iTrader: (43)

No they're 2 differant styles
Left and right sides are just reverse images of each other

80 MONZTA

Any info about where these place the rear of the block compared to a gen 1?

poconojoe

iTrader: (43)

The longer one places the back of the block approx the same place as the GEN 1 would be. The shorter one places it further forward, this is to allow for the fact that the GEN 3 blocks don't have the extension between the back of the block and the back of the head. In some application the back of the head with be too close to the firewall

80 MONZTA

Thanks, that is very usefull info.

chevelle598bb

iTrader: (5)

I made mine off of those templates. The measurements are dead on.