dnkynrbk

iTrader: (34)

Did a search and couldnt find where they are. So where did you guys get your stereo delete panel at?

mike135531bubba

iTrader: (45)

try page 4 in this section lol

dnkynrbk

iTrader: (34)

I saw that but I found one on here before that had a link to a place that you could order one.

mike135531bubba

iTrader: (45)

you could make your own for fairly cheap, not sure why people order these

phoenix

iTrader: (6)

i had made one out of abs plastic and just sandwich it between the trim cover and the dash pad. work pretty good. now i got a switch panel there.

TS6

iTrader: (41)

Yup...

sweetbmxrider

iTrader: (13)

http://6litereaterdesigns.com/store/...products_id=52

maybe? i'd just get some abs plastic off ebay and have it though. its fun.

Reboot

iTrader: (5)

I did the same but also glued a piece of thin aluminum to the back with holes for the push pins to go through. 59 cents total and won't move unless I want to remove it.

JL ws-6

iTrader: (50)

I made my own out of abs plastic, cut it on my table saw and used a dremel to finish gettnig it to fit right.

Easy to do, just take your time. I bought the abs thru some mail order stereo supply place, got like 3 sheets for 20 bucks or something, enough to make about 50 of them LOL.

AChotrod

iTrader: (17)

I got mine from a Stock Eliminator racer that got it from GM b4 they were discontinued. Now I just need to get off my *** and install it.

dnkynrbk

iTrader: (34)

lmao. I know how that goes

AChotrod

iTrader: (17)

Heck, Ive also got 2k in Nitrous parts just laying around too. Damn Im lazy lol

GIZMO

iTrader: (8)

Because they look so good!

jmill96Z

iTrader: (3)

^^ That does look pretty good.

rmata

iTrader: (34)

I would just buy the sheets if plastic like the others stated. It's fairly cheap and pretty easy to do. Plus, you get to customize it to whatever you want

AChotrod

iTrader: (17)

Installed mine last night and it looks just like yours. Thanks again!

01sscam

I really like how you did this, I may steal your idea an put my micro edge in the same location.

Fireball

iTrader: (21)

I just fabbed something out of some scrap sheetmetal I had and painted black
I may redo it in carbon fiber though...

Sideways240sx

iTrader: (22)

I did this prolly 4-6 mo's ago.. Not done just yet, should have it in the car in the next couple of weeks.

o2bird

Here's one i had beer make for me