Question about installing stock crank pulley?
#1
Question about installing stock crank pulley?
I have a 97 corvette ls1 that I'm putting the stock pulley back on the crank!how do I know if it's on all the way,will the inner edge of pulley sit flush with the end of the crank??
#4
TECH Senior Member
iTrader: (4)
There is a procedure that should be followed and part of it is the measurement from the edge of the pulley hub to the end of the crank snout. Don't use a bolt to pull it on.
I posted the service manual procedure recently in post #7 of this thread: Link
I posted the service manual procedure recently in post #7 of this thread: Link
Last edited by vettenuts; 01-26-2011 at 04:31 AM.