Drill mod question
05-06-2011, 07:47 PM
#1
Teching In
Thread Starter
Join Date: Jun 2008
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Drill mod question I'm replacing my clutch with a Monster LV2 and putting in a new master as well. My question concerns the drill mod and how far to drill. I've drilled down about 1.5 inches thru several spots of resistance and hit resistance again. Should I continue or am I going too far?
05-07-2011, 10:58 AM
#2
Teching In
Thread Starter
Join Date: Jun 2008
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Yep needed to continue drilling. Drilled thru the last spot of resistance and the 1/8 bit moves freely it's full 3 inch length. The Monster extended bleeder is NICE, putting the master back in the firewall.....not so nice! :-)
