jlynch799

ok so im a tightwad on cash and had a old set of heads from a 2000 camaro ls1. and i have my other heads off a 2003 z06. i noticed that the valves off the z06 are .6mm (.023622") longer. i installed the valves from the camaro into the z06 due to the z06 bent some valves. would i be able to just buy the .025 longer push rods to make up the diffrence and be ok.. thanks for the help

94mustang

iTrader: (1)

That little bit isn't going to make a big difference. But yes you are thinking correctly. Just make sure your preload is set right and check your geometry.

A.R. Shale Targa

iTrader: (2)

Rocker arm geometry changes things a bit. .001 pushrod length times 1.7
rocker arm ratio equals .0017 at the valve.

jlynch799

the diffrence is .002, was thinking that the lifter might be able to take up the slack, i dont want to deystroy my cam or have engine damage. just wondering if anyone has tried this before. so if i have to i would get new valves.

5.3LJimmy

iTrader: (10)

Is this going to be installed on an LS6 with the factory camshaft? The reason the LS6 valves are longer is to make up for the reduced base circle of the stock LS6 cam. This allowed them to retain the same pushrod length as all other Gen 3 engines.

jlynch799

i installed a gm hot cam, will that have the same small base?

jlynch799

so i just ordered the push rods that are 7.425 hope that will help out