allout06

iTrader: (11)

Its gettin closer to me being able to install my procharger. My question is, can I install this a piece at a time? I'm going to install a clutch next week and while I had access to a lift I was going to install the hedunit and the crank pullies and just leave the belt off. Would this hurt anything? As long as I put covers over the headunit inlet/outlet? I'll have my intercooler also but no BOV valve yet. Thought about running it all too except for the part going into the TB. Its a FMIC btw. Along with installing the radiator shroud. I just can't run it until I get my fuel pumps installed along with a catch can and my BOV which would b a week later. Thanks.

crashinaz

iTrader: (35)

As long as you leave the belt off, cap everything and leave your NA intake stuff in place... You can install anything that fits without a problem.

Bob@BruteSpeed

iTrader: (16)

Keep the larger fuel injectors out of it until the new tune is added and you won't have any problems. Bob

allout06

iTrader: (11)

Ok kool. Thanks guys!

TermnEatr

iTrader: (24)

Curious what should u yse to cap it im doin the same thing

allout06

iTrader: (11)

We've got some rubber boots at work that'd work well. So I think I'll pick up some of them and some band clamps. Something water resistant for sure I'd imagine.