Setting up LC1 in EFI Live
#1
Setting up LC1 in EFI Live
I have the controller wired in and am using a TAQquickness serial cable.
When I first connected it and turned it on it did heater calibration and everything then went to a screen that says Free Air and a percentage.
It keeps jumping from 20.8-20.9%. If I hit "OK" it says W02 Not Found.
Am I doing it wrong?
When I first connected it and turned it on it did heater calibration and everything then went to a screen that says Free Air and a percentage.
It keeps jumping from 20.8-20.9%. If I hit "OK" it says W02 Not Found.
Am I doing it wrong?