Clear Airlid, then SES?
03-29-2004, 02:55 PM
#1
On The Tree
Thread Starter
Clear Airlid, then SES? Did anyone else throw a code after the Airlid install? I didn't at first, but now I have one. Also installed a smooth bellows but that shouldn't make a difference, should it?
03-29-2004, 04:59 PM
#2
12 Second Club
iTrader: (17)
Join Date: Sep 2003
Location: Richmond, VA
Posts: 1,199
Likes: 0
Received 0 Likes
on
0 Posts
double check the IAT sensor plug to make sure it's in all the way, if not, it will throw a code for high voltage (meaning it's not plugged in). Hope that helps.
Robbie
Robbie
03-29-2004, 07:13 PM
#3
TECH Fanatic
iTrader: (4)
Join Date: Jan 2004
Location: Manhattan, KS
Posts: 1,126
Likes: 0
Received 0 Likes
on
0 Posts
Was about to say the same 
Other than that, I have never heard of installing a lid and/or smooth bellows that would throw a code. Get it scanned before you do anything though, it could be anything, probably something not related to the lid/bellows at all
Other than that, I have never heard of installing a lid and/or smooth bellows that would throw a code. Get it scanned before you do anything though, it could be anything, probably something not related to the lid/bellows at all
03-29-2004, 07:28 PM
#4
Staging Lane
Join Date: Dec 2003
Location: Los Angeles
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
I threw an SES code when I did the FRA mod. Took it to the dealer and they said it was two air sensors or something like that. They replaced it under warranty. Maybe something similiar since both mods add more air to the engine. Good luck!
Bob
Bob
03-29-2004, 07:47 PM
#5
Could be the IAT, you may of damaged it. Check the other wires around there too. I did a spark plug wire change and got and SES code 15 miles later, turned out to be bad AIR valves, so the lesson is it may not have anything to do with the lid.
