Ford 9" on a 2002 Camaro?
#1
Ford 9" on a 2002 Camaro?
Does this work? one of my friends says he has an old ford 9" laying around and i want to go take a look at it. I know ill need to measure it and make sure it is the same width, but what about all the other brackets and stuff like that? does it take much modifications to make it fit in there?
#4
TECH Junkie
iTrader: (18)
Join Date: Aug 2005
Location: Amsterdam Ny, the good part
Posts: 3,400
Likes: 0
Received 66 Likes
on
53 Posts
i want to build one for my car amd just need to find one the same width . the leaf springs and the mounts i have an can make i just want a bare junkyard housing the right length .
Trending Topics
#8
12 Second Club
iTrader: (7)
I read a thread where a guy only wanted to buy the torque arm mount from Moser and they wouldn't sell him one. You have to buy the housing and TA mount together. Probably if you had one of thier rears and broke the mount they would sell you one. Bob at Brute Speed would know.
#9
11 Second Club
iTrader: (3)
Join Date: Feb 2010
Location: The Beach
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Midwest Chassis Fab 9 "
Midwest Chassis makes a very nice Fabricated Bolt in 9" for your car.
I have a Midwest Chassis Fab 9 in my 1998 Camaro. Incredible Rear end !
I have a Midwest Chassis Fab 9 in my 1998 Camaro. Incredible Rear end !
Last edited by NOS LS1; 01-03-2013 at 10:24 PM. Reason: Picture
#11
LS1Tech Sponsor
iTrader: (16)
http://shop.brutespeed.com/Moser-9-I...-and-Axles.htm
http://shop.brutespeed.com/Moser-M9-...using-Axle.htm
You could fab up a used rear and probably save a little money, although I doubt you'll save as much as you think you will. The above two Moser packages are a good way to go, in which you can install a used center section and have a rear ready to go.
Moser doesn't sell the torque arm mount by itself. Currie does sell the torque arm mount as has been mentioned. Bob
http://shop.brutespeed.com/Moser-M9-...using-Axle.htm
You could fab up a used rear and probably save a little money, although I doubt you'll save as much as you think you will. The above two Moser packages are a good way to go, in which you can install a used center section and have a rear ready to go.
Moser doesn't sell the torque arm mount by itself. Currie does sell the torque arm mount as has been mentioned. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website