Help out a motor newbie....
04-20-2004, 08:34 PM
#1
12 Second Club
Thread Starter
Join Date: Dec 2002
Location: SE Mass USA
Posts: 565
Likes: 0
Received 0 Likes
on
0 Posts
Help out a motor newbie.... Im looking to start up a new motor project. I was thinking of starting out with the 6.0 iron block, with a healthy bore and stroke. On top of that Id like to slap on a turbo or two and see what happens from there.
I was wondering if you guys could throw me some info on how to go about this, what would be a good bore/stroke to do, and still allow enough tolerances to run alot of boost. This will also be a street car seeing mostly track time but will still be driven on the street.
Im not looking to get this done this summer or anything, im just looking for a project to start and slowly finish....Im in no rush so time and money are not an issue.
Much appreciated.
Mark
I was wondering if you guys could throw me some info on how to go about this, what would be a good bore/stroke to do, and still allow enough tolerances to run alot of boost. This will also be a street car seeing mostly track time but will still be driven on the street.
Im not looking to get this done this summer or anything, im just looking for a project to start and slowly finish....Im in no rush so time and money are not an issue.
Much appreciated.
Mark
